Miller Millermatic 140 MIG Welder with Auto-Set (907335)

This item is no longer available from Miller. The Millermatic 140 has now been replaced by the Millermatic 141 MIIG Welder. If you'd prefer to view all our Miller Welding Equipment, click here.

If you're looking for a MIG welder that is affordable, easy to set up, and still packs features found in more expensive units, the Miller Millermatic 140 MIG Welder with Auto-Set is for you.

Miller's advanced Smooth-Start technology provides a smooth, spatter-free start. They even make the claim that this is the best starting machine in the small MIG category. No more pop-gun starts or spatter to clean up. The Durable Cast Aluminum Drive System incorporates dual groove quick-change drive roll and spring-loaded tension arm with calibrated tension knob; all designed to make setup easier and faster. Standard built-in, solid-state contractor circuit makes wire electrically "cold" until trigger is pulled. This makes the unit safer and torch easier to position before starting to weld.

Auto-Set
A breakthrough control that automatically sets your welder to the proper parameters. Auto-Set offers all-in-one MIG minus the guesswork! Simply set the wire diameter, set the material thickness and start welding!

Manual Mode
Gives you the flexibility to manually set the machine when welding aluminum, stainless steel or anytime you want to set your own parameters on mild steel.

Thermal Overload Protection
Shuts down the unit and activates an over-temperature light if airflow is blocked or duty cycle is exceeded. Automatically resets when fault is corrected and unit cools.

Standard Built-In Solid State Contractor Circuit
Makes wire electrically "cold" until trigger is pulled. This makes the unit safer and torch easier to position before starting to weld.

Smooth-Start
This technology provides a smooth, spatter-free start. The best starting machine in the small MIG category! No more pop-gun starts or spatter to clean up.

Durable Cast Aluminum Drive System
Incorporates dual groove quick-change drive roll and spring-loaded tension arm with calibrated tension knob, all designed to make setup easier and faster.

'Tip Saver' Short Circuit Protection
Shuts down output when tip is shorted to the work, extending contact tip life and protecting internal components from damage. Trigger reset permits quick reset at torch rather than unit.

Easy Access to Output Studs
Convenient polarity changeover when switching from solid or flux cored wires.

Comes complete with:
• Millermatic 140 power source
• 6 ft (1.8 m) power cord and plug
• 10 ft (3 m), M-100 MIG gun and cable assembly
• 10 ft (3 m) work cable and clamp
• Smith Argon and AR/CO2 mix regulator/flowgauge with hose
• Spool of Hobart .030 in (0.8 mm) solid wire
• Two contact tips for .024 in (0.6 mm) wire and two contact tips for .030 in (0.8 mm) solid wire
• Dual-groove quick-change drive roll for .024 in (0.6 mm) or .030/.035 in (0.8/0.9 mm) solid wire
• Information/settings chart