Motor Guard Plasma Air Filter Kit for Miller, Thermal Dynamics, and Lincoln
*No payments, No interest for 6 months! Check Out with Paypal
If your air isn't spray paint quality, then your eating up your tips and electrodes with dirty or wet air. This filter sold with case of 4 replacement elements should save you it's cost in no time. Same Filter And Replacement Elements Sold By Miller For $230.00.
Motm-26 And Motm-723
|Plasma Cutting Systems: Compressed Air Filter|
A Sub-Micronic Compressed Air Filter that effectively removes oil aerosols and condensed moisture...and will:
The installation of a Motor Guard Filter on the Plasma Cutting system downstream of the air regulator will effectively remove the contamination from the compressed air line. This eliminates the "sputter" from the arc, restoring the plasma system to maximum cutting efficiency, and dramatically reducing the corrosive wear on the tip and electrode.
Designed to remove the smallest contaminant, oil-aerosol or drop of moisture to supply Clean, Dry, Oil-Free air to the point of use. Users of the filters report contaminant free air with higher flow rates and minimal pressure drops.
|Compressed Air Filter - Plasma Cutting Systems|
|Model No.||Pipe Size||Max Flow |
|M-26||1/4 Npt||2700 Scfh||125 psi||175 F||.01 Micron||5" x 7"||M-723|
|Mfgs MPN||MOTM-26, MOTM-723|
|Skill Level||Weekend Warrior, Career Welder|